Reverse Engineering

Recreating a Splined Shaft Without OEM Drawings

Published on:
November 4, 2026

When the manufacturer of a critical shaft was no longer in business, ordering a replacement was not an option. Without original drawings to work from, Multi-Automatic reverse engineered the existing two-piece splined shaft to create the specifications needed for a replacement.

‍

At a glance

Challenge: A 33-inch, two-piece splined shaft needed to be replaced, but the OEM was no longer in business and original drawings were unavailable.

Solution: Reverse engineer the existing shaft components to establish the required specifications and tolerances.

Result: Multi-Automatic created the information needed to reproduce the shaft despite the absence of OEM support or original documentation.

‍

The Challenge

No OEM. No drawings. No straightforward replacement.

The customer needed a replacement for a 33-inch, two-piece splined shaft.

Normally, original equipment drawings or OEM support would provide the specifications needed to manufacture or source a replacement. In this case, neither was available. The original equipment manufacturer was no longer in business, and drawings for the shaft could not be obtained.

That left the existing components as the primary source of information for determining how a replacement needed to be made.

‍

The Solution

Reverse engineer what still exists

Multi-Automatic used the existing shaft components to reverse engineer the part.

The team evaluated the individual pieces and recreated the specifications and tolerances needed to reproduce the shaft. The splined geometry and other critical features had to be captured from the existing components rather than an original engineering drawing.

By working backward from the physical parts, Multi-Automatic was able to develop the information needed to move the replacement forward.

‍

Customer testimonial

“The shaft worked perfectly. Thank you for everything.”

‍

The Results

A path forward without the original manufacturer

The lack of OEM support and original drawings did not end the search for a replacement.

Through reverse engineering, Multi-Automatic recreated the specifications and tolerances of the existing shaft components, providing the technical information needed to reproduce the two-piece splined shaft.

The project demonstrates where reverse engineering can be especially valuable: when the equipment still needs to be supported but the documentation and manufacturer behind it are no longer available.

‍

When the drawings are gone, the part can still tell you a lot

Older and specialized equipment does not always come with the documentation needed to order a replacement. When an existing component is available, reverse engineering may provide another way forward.

Multi-Automatic can evaluate existing parts and assemblies, recreate critical specifications and tolerances, and help determine whether a replacement can be produced.

Have an obsolete part without a drawing?

Talk With a Product Specialist

‍

Share This:
Copy to Clipboard LinkLinkedIn LinkTwitter linkFacebook link
[https://multi-auto.webflow.io/case-studies/](https://multi-auto.webflow.io/case-studies/){{ reverse-engineering-a-33-inch-splined-shaft-without-oem-drawings }}
Reverse Engineering